Apparently, the US-Spec exhaust routing is different from the Japan-Spec system. And so, the staff had to create a new exhaust jig from scratch.

While the exhaust jig was being created, the other staff members installed the Tanabe Front Strut Tower Bar.

Above - A closeup of the tower bar end-plate

Meanwhile, the muffler for the new exhaust was being lined up and measured.

Measurements for the exhaust jig were noted, followed by the installation of the S-0C coilovers. Above - Front coilover installed.

Above - Rear S-0C installed

In the next section, the staff takes a look at the height range testing for the new S-0C coilovers on the Cube. Check it out!